• For professional use only!
• BEFORE USING, READ AND UNDERSTAND ALL LABEL INSTRUCTIONS AND MATERIAL SAFETY DATA SHEETS.
• For technical advice call our Loba-Wakol Technical Service at 1-800.230.6456.
• Recommended climate conditions are 55°F-80°F/40-75%rH.
• Sand and prepare floors according to NWFA guidelines.
• WARNING! If you scrape, sand, or remove old paint from wood floors, you may release lead dust. Follow local and/or federal requirements for lead removal. Before you start, find out how to protect yourself and others by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
• ALWAYS PREPARE A SAMPLE OR TEST AREA TO DETERMINE COMPATIBILITY, APPEARANCE, AND DESIRED RESULTS.
• Do not apply at temperatures below 55°F (13°C). Make sure material is at room temperature. Always maintain adequate ventilation during all phases of the coating and drying process.
• Any unused dry material can be reconstituted with warm or hot water.
• Completely sand all dried material from the surface during your final sanding phase.
• Requires the application of at least two coats of finish.

Application Tool

Coverage

Drying time

• • Sanding possible after approximately 30-40 minutes. Extremely wide gaps may require overnight drying.
  • It is possible to apply LOBA water-based & LOBA oil systems as soon as 1 hour after application.

Recommended procedure for wood floors:

• Sand to your medium grit sanding sequequence.
• Fill with LOBA TrowelFill.
• Allow to dry 30-40 min.
• Final cut.
• Apply surface treatment according to Technical Data Sheet of the product.
  Tip: Wider gaps in flooring may need an additional filling.
  Tip: The custom coloring of LOBA TrowelFill can be achievedby adding Mixol Universal Pigment or equivalent at the discretion of the wood flooring professional.

Suitable product combinations

Possible surface treatment with:

Screen and Recoat

• Requires the application of at least two coats of finish.
• Completely remove all dried material from the surface during your final sanding phase.
• Must be coated with LOBA water-based sealers, finishes, or LOBA oil systems.